Supero SUPERSERVER 6023P-8, User Manual

Page: 23 / 104

Chapter 2: Server Installation
2-7
2-5 Checking the Motherboard Setup
After you install the 6023P-8R/6023P-8 in the rack, you will need to open
the unit to make sure the motherboard is properly installed and all the con-
nections have been made.
1. Accessing the inside of the 6023P-8R/6023P-8 (see Figure 2-5):
First, release the retention screws that secure the unit to the rack.
Grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click"). Next, depress the two buttons on the top
of the chassis to release the top cover. There is a large rectangular
recess in the middle front of the top cover to help you push the cover
away from you until it stops. You can then lift the top cover from the
chassis to gain full access to the inside of the server.
2. Check the CPUs (processors):
You should have one or two processors already installed into the
system board. Each processor needs its own heatsink. See Chapter
5 for instructions on processor and heatsink installation.
3. Check the system memory:
Your 6023P-8R/6023P-8 server system may have come with system
memory already installed. Make sure all DIMMs are fully seated in their
slots. For details on adding system memory, refer to Chapter 5.
4. Installing add-on cards:
If desired, you can install add-on cards to the system. See Chapter 5 for
details on installing PCI add-on cards.
5. Check all cable connections and airflow:
Make sure all power and data cables are properly connected and not
blocking the chassis airflow. Also make sure that no cables are posi-
tioned in front of the fans. See Chapter 5 for details on cable connec-
tions.