5-8
S
UPER
S
ERVER 5013G-6/5013G-i Manual
5-7
Adding PCI Cards
1. 32-bit PCI slot
The P4SGR/P4SGE has six 32-bit, 33 MHz 5V PCI slots. A riser card de-
signed specifically for use in the 810 1U rackmount chassis is included with
your system. This riser card allows an installed PCI card to sit at a 90
degree angle so it can fit inside the chassis. This riser card accommo-
dates 32-bit, 33 MHz 5V PCI cards (see Figure 5-6).
2.
PCI card installation
Before installing a PCI add-on card, locate the PCI riser card mentioned in
Step 1. Begin by removing the shield for the PCI slot you wish to populate.
Fully seat the PCI card into the riser card and screw it into the metal reten-
tion rail. Then, insert the riser card into the PCI slot on the motherboard,
pushing down with your thumbs evenly on both sides of the card. Finish by
using a screw to secure the top of the card shield to the rear of the
chassis. The PCI shields protect the motherboard and its components from
EMI and aid in proper ventilation, so make sure there is always a shield
covering each unused PCI slot.
Figure 5-6. 32-bit, 33 MHz 5V Riser Card
Summary of Contents for SUPERSERVER 5013G-6
