Supero SUPERSERVER 5013G-6, User Manual

Page: 13 / 110

Chapter 1: Introduction
1-3
Processors
The P4SGR/P4SGE supports single 478-pin Pentium 4 microPGA processors
at up to 3.06 GHz at a front side (system) bus speed of 533 or 400 MHz.
Please refer to the support section of our web site for a complete listing of
supported processors (http://www.supermicro.com/TechSupport.htm).
Memory
The P4SGR/P4SGE has two (2) 184-pin DIMM sockets that can support up to
2 GB of non-ECC unbuffered PC2700/2100 (DDR-333/266) low-profile
SDRAM modules. Module sizes of 128 MB, 256 MB, 512 MB and 1 GB may
be used to populate the DIMM slots.
Onboard SCSI (5013G-6 only)
Onboard SCSI is provided with an Adaptec AIC-7899 SCSI controller chip,
which supports dual channel, Ultra160 SCSI at a burst throughput rate of
160 MB/sec for each channel. The P4SGR provides two SCSI ports: one
internal 68-pin LVD Ultra160 connector (on Channel A) and one external/
internal (shared) 68-pin Ultra160 SCSI connector (channel B).
PCI Expansion Slots
The P4SGR/P4SGE has six 32-bit, 33 MHz PCI slots available. One riser
card is included with the system for use with 32-bit PCI cards.
Network Interface Controllers (NIC)
The P4SGR/P4SGE supports two Gb LAN ports (or Network Interface con-
trollers -NIC) based on Intel's 82540EM Ethernet controller chip.
Onboard Controllers/Ports
An onboard IDE controller supports one floppy drive and up to four UDMA/
100 hard drives or ATAPI devices. Onboard I/O ports include one COM port,
one parallel port, two USB ports, PS/2 mouse and keyboard ports, a VGA
(graphics) port and two LAN (NIC) ports.