Supero SuperServer 1025C-M3, User Manual

Page: 64 / 110

6-2
S
UPER
S
ERVER 1025C-M3 Manual
Figure 6-1. Chassis: Front and Rear Views
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the appropriate header on the Control
Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both
connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Installation."
6-3 System Cooling
Four 4-cm fans provide the cooling for the system. The SC113M chassis provides
two additional open fan housings, where an additional system fan may be added
for optimal cooling.
It is very important that the chassis top cover is properly installed and making a
good seal in order for the cooling air to circulate properly through the chassis and
cool the components. See Figure 6-2.
Control Panel DVD-ROM Drive
Hot-Swap Drive Bays (8)
PCI Slot COM Port Mouse/Keyboard Power Supply
USB Ports LAN Ports
VGA Port