Chapter 5: Optional Accessories
5-21
Mounting a Cable Management Trough to a Vertical Plate
To mount a cable management trough to a vertical plate, use the procedure
below.
Mounting a Cable Management Trough to a Vertical Plate
1. Insert the vertical plate's slots
or pegs so that they slide into
the matching slot or peg support
holes on the vertical plate.
2. Screw in the two retaining
thumb screws through the cable
management trough into the
matching holes in the vertical
plate.
Note:
The 70mm vertical plate can only mount cable management troughs using
pegs, whereas the 130mm vertical plate and rear extensions can mount cable
managment troughs using both pegs and mounting slots.
Note:
You can also mount cable management troughs without a vertical plate
on a bare SuperRack frame by their pegs or slots and by using spring screw
holes to secure them. This method is not as secure as mounting them to a
vertical plate though.
Unmounting a Cable Management Trough from a Vertical Plate
To unmount a cable management trough from a vertical plate on the rack, follow the
previous procedure in reverse by fi rst unscrewing its retaining thumb screws, and
then unmounting the cable management trough from the vertical plate.
