Supero SUPER P4DL6, User Manual

Page: 31 / 92

Chapter 2: Installation
2-5
To Remove:
Use your thumbs to
gently push near the
edge of both ends of
the module. This
should release it from
the slot.
Figure 2-2. Installing and Removing DIMMs
To Install:
Insert the module vertically
and press down until it
snaps into place. Pay
attention to the notch on
the bottom of the module.
2-3 Installing DIMMs
Note: Check the Supermicro web site for recommended memory modules:
http://www.supermicro.com/TECHSUPPORT/FAQs/Memory_vendors.htm
CAUTION
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
DIMM Installation (See Figure 2-2)
1. Insert an even number of memory modules. The interleaved memory
scheme requires you to install two modules at a time beginning from the
last bank and making your way to Bank 1.
2. Insert each DIMM module into its slot. Note the notch at the bottom of the
module to prevent inserting the module incorrectly.
3. Gently press down on the DIMM module until it snaps into place in the
slot. Repeat for all modules (see step 1 above).
Support
The P4DL6/P4DLR+/P4DLR supports ECC registered PC1600 (DDR-200)
SDRAM memory. An interleaved memory configuration is used (see step 1
above). PC2100 memory is supported but only at 200 MHz (PC1600 speed).