Supero MicroCloud 5038ML-H8TRF, User Manual

Page: 55 / 122

Chapter 5: Advanced Motherboard Setup
5-7
Warning: Exercise extreme care when installing or removing DIMM modules to prevent
any possible damage.
5-5 Installing Memory
Installing DIMMs
1. Insert the desired number of DIMMs into the DIMM slots, starting with DIM-
MA2. Pay attention to the notch along the bottom of the module to prevent
incorrect installation. Use memory modules of the same type and speed.
2. Retract the slot's release tabs then insert the DIMM module vertically. Push
down until it and snaps into place. Repeat to install more memory if needed.
Memory Support
Each X10SLD-F supports up to 32GB of ECC Unbuffered (UDIMM) DDR3-
1600/1333/1066 memory in four slots. Populating these DIMM modules with a
pair of memory modules of the same type and same size will result in interleaved
memory, which will improve memory performance. Please refer to the table below:
S-SGPIO1
S-SATA /SAS2
I-SATA4
JSD1
J2
JWD1
JPME2
JPME1
JPG1
JBT1
SW1
LE5
LED5
LED6
JKVM1
JUIDB1
CPU Slot1 PCI-E 3.0 x8
VBA
T
IPMI_LAN
UID
Micro-LP PCI-E 3.0 x8
PWR
DIMMB2
DIMMB1
DIMMA2
DIMMA1
BIOS
S-SATA /SAS3
S-SATA /SAS0
S-SATA /SAS1
USB0 (3.0)
JTPM1
X10SLD-F/HF
Rev
. 1.00
Intel PCH
BMC
CPU1
Warning: Exercise extreme care when installing or removing DIMM modules to prevent
any possible damage.
To Install: Insert
module vertically
and press down
until it snaps into
place. Pay attention
to the alignment
notch at the bottom.
To Remove:
Use your thumbs to
gently push the re-
lease tabs near both
ends of the module.
This should release
it from the slot.
Figure 5-2. DIMM Installation
Top View of DDR3 Slot
Release Tab
Release Tab
Notch should align
with the receptive
key point on the slot.
Notch
Notch
Front View