Supero FatTwin F617R2-F73, User Manual, Page: 93 / 144

Chapter 6: Advanced Chassis Setup
6-9
Installing a 2.5" Drive into the Hard Drive Carrier
1. Remove the two screws holding the drive to the carrier.
2. Remove the drive from the carrier.
3. Install a new drive into the carrier with the printed circuit board side facing
down so that the mounting holes align with those in the carrier.
4. Secure the hard drive by tightening all four screws.
Figure 6-9: Installing a 2.5" Hard Drive in the Drive Carrier
2.5" Drive Carrier
SAS or SATA
Hard Drive
Install Screws
From Beneath the
Drive Carrier
1
4
5. Use the open handle to replace the drive carrier into the chassis. Make sure
to close the drive carrier handle.
Note that if a node is pulled out of the chassis, the hard drives associated with
that node will power down as well. The hard drives are hot-swappable and may be
removed from the node without removing the node from the chassis or powering
down the system.
Caution: Enterprise level hard disk drives are recommended for use in
Supermicro chassis and servers. For information on recommended HDDs,
visit the Supermicro Web site at http://www.supermicro.com/products/nfo/fi les/
storage/SAS-CompList.pdf