Supero A+ SERVER 2042G-6RF, User Manual

Page: 51 / 114

Chapter 5: Advanced Serverboard Setup
5-3
5-3 Connecting Cables
Now that the serverboard is installed, the next step is to connect the cables to the
board. These include the data (ribbon) cables for the peripherals and control panel
and the power cables.
Connecting Data Cables
The ribbon cables used to transfer data from the peripheral devices have been
carefully routed to prevent them from blocking the flow of cooling air that moves
through the system from front to back. If you need to disconnect any of these cables,
you should take care to keep them routed as they were originally after reconnecting
them (make sure the red wires connect to the pin 1 locations). The following data
cables (with their locations noted) should be connected. (See the layout on page
5-9 for connector locations.)
•
SAS/SATA drive data cables (SAS0-5/SATA0-5)
•
Control Panel cable (JF1)
•
DVD-ROM drive cable (J3)
•
USB cable (USB5/6)
•
COM port cable (COM2)
Important! Make sure the cables do not come into contact with the fans.
Connecting Power Cables
The H8QG6/i-F has a 24-pin primary power supply connector (JPW1) for connection
to the ATX power supply. In addition, there are three 8-pin secondary power
connectors (JPW2/3/4) that also must be connected to your power supply. See
Section 5-9 for power connector pin definitions.
Connecting the Control Panel
JF1 contains header pins for various front control panel connectors. See Figure 5-1
for the pin locations of the various front control panel buttons and LED indicators.
All JF1 wires have been bundled into a single ribbon cable to simplify this connection.
Make sure the red wire plugs into pin 1 as marked on the board. The other end
connects to the Control Panel PCB board, located just behind the system status
LEDs on the chassis. See Section 5-9 for details and pin descriptions.