5-18
A+ Server 1012A-MRF User's Manual
5-9 Jumper Settings
Explanation of Jumpers
To modify the operation of the motherboard,
jumpers can be used to choose between
optional settings. Jumpers create shorts be-
tween two pins to change the function of the
connector. Pin 1 is identified with a square
solder pad on the printed circuit board. See
the diagram at right for an example of jump-
ing pins 1 and 2. Refer to the motherboard
layout page for jumper locations.
Note:
On two-pin jumpers, "Closed" means
the jumper is on and "Open" means the
jumper is off the pins.
Connector
Pins
Jumper
Setting
3 2 1
3 2 1
CMOS Clear
JBT1 is used to clear CMOS, which will also clear any passwords. Instead of pins,
this jumper consists of contact pads to prevent accidentally clearing the contents
of CMOS.
To Clear CMOS
1. First power down the system and unplug the power cord(s). It is also recom-
mended that you remove the onboard battery from the serverboard.
2. With the power disconnected, short the CMOS pads with a metal object such
as a small screwdriver.
3. Remove the screwdriver (or shorting device).
4. Reconnect the power cord(s) and power on the system.
Note 1.
For an ATX power supply, you must completely shut down the system,
remove the AC power cord, and then short JBT1 to clear CMOS.
Note 2.
Be sure to remove the onboard CMOS Battery before you short JBT1 to
clear CMOS.
Note 3.
Clearing CMOS will also clear all passwords.
Note 4:
Do not use the PW_ON connector to clear CMOS.
JBT1 contact pads
Summary of Contents for A+ 1012A-MRF
