Supero 5028R-E1CR12L, User Manual

Page: 54 / 134

5-8
S
UPER
S
TORAGE
S
YSTEM 5028R-E1CR12L User's Manual
5-5 Installing Memory
Caution: To prevent possible damage, exercise extreme caution when installing or
removing DIMMs.
Installing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with slot
DIMMA1. Pay attention to the notch along the bottom of the module to pre-
vent inserting the DIMM module incorrectly. See Figure 5-4.
2. Push the release tabs on both ends of the DIMM slot outwards to unlock it.
3. Align the key of the DIMM with the receptive point on the memory slot.
4. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat step 1 to install additional DIMMs.
Memory Support
The X10SRH-CLN4F has eight DIMM sockets that can support up to 256 GB of
RDIMM (registered DIMM) or 512 GB of load-reduced DIMMs (LRDIMMs) DDR4-
1866/1600/1333/1066/800 DDR3 memory.
Check the Supermicro web site for recommended memory modules and updates
to supported memory
Figure 5-4. DIMM Installation
Socket Key
Release Tab
Release Tab
Notes
•
Be sure to use memory modules of the same type, speed, and capacity
on the motherboard. Mixing of memory modules of different types and
speeds is not allowed.
•
Due to memory allocation to system devices, the amount of memory that
remains available for operational use will be reduced when 4 GB of RAM
is used. The reduction in memory availability is disproportional. See the
table on the following page for details.