Supero 5028R-E1CR12L, User Manual

Page: 105 / 134

Chapter 7: BIOS
7-21
Serial ATA Port 0~ Port 5
This item displays the information detected on the installed SATA drives on the
particular SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
Port 0~ Port 5
Select Enabled to enable a SATA port specified by the user. The options are
Disabled and Enabled .
Port 0 ~ Port 5 Hot Plug
Select Enabled to enable hot-plugging support for a port specified by the user,
which will allow the user to replace a SATA disk drive installed on this port without
shutting down the system. The options are Enabled and
Disabled .
Port 0 ~ Port 5 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization to the device. The options are Enabled and
Disabled
.
Port 0 ~ Port 5 SATA Device Type
Use this item to specify if the SATA port specified by the user should be con -
nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk
Drive and Solid State Drive.

sSATA Configuration
When this submenu is selected, AMI BIOS automatically detects the presence of
the SATA devices that are supported by the PCH-sSATA controller and displays
the following items:
sSATA Controller
This item enables or disables the onboard SATA controller supported by the Intel
PCH-sSATA controller. The options are
Enabled and Disabled.
Configure sSATA as
Select IDE to configure an sSATA drive specified by the user as an IDE drive. Select
AHCI to configure an sSATA drive specified by the user as an AHCI drive. Select
RAID to configure an sSATA drive specified by the user as a RAID drive. The op
-
tions are IDE,
AHCI
, and RAID.