Supermicro X11DPU-X, User Manual

Page: 13 / 129

13
Chapter 1: Introduction
Quick Reference Table
Jumper Description Default Setting
JBT1 CMOS Clear Open (Normal)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
JPME2 Manufacturing Mode Pins 1-2 (Normal)
JWD1 Watch Dog Timer Enable Pins 1-2 (Reset)
LED Description Status
LE2 Standby PWR LED Green: Standby Power On
LED1 UID LED Solid Blue: Unit Identified
LEDM1 BMC Heartbeat LED Blinking Green: Normal
Connector Description
BT1 Onboard CMOS Battery
COM1 COM Port
FAN1 ~ FAN8 System/CPU Fan Headers (FAN1: CPU Fan)
IPMI_LAN JLAN1 IPMI-Dedicated LAN Port
I-SATA0 ~ I-SATA7 SATA 3.0 ports supported by Intel PCH
JF1 Front Control Panel Header
JGPW1 - JGPW4 (GPU PWR1 - GPU PWR4) Power connectors used for GPU and VGA devices
JIPMB1 System Management Bus Header for IPMI 2.0
JL1 Chassis Intrusion Header
JNVI
2
C1, JNVI
2
C2 VPP_CPU1, VPP-CPU2 - System Management Bus
JP2 Complex Programmable Logic Device (CPLD) header
JPW1 - JPW4 (BP PWR1 - BP PWR4) Backplane power connectors for hard drives
JRK1 Intel RAID key header for NVMe Solid State Devices (SSD)
JSDCARD1 SD Card Socket
JSD1 - JSD2 SATA Disk-on-module (DOM) Power Connectors
JTPM1 TPM/PORT80 Trusted Platform Module/Port 80 Connector
JUIDB2 Unit Identifier (UID) Switch
JUSB3 USB3/4(3.0) Internal USB header for two USB 3.0 connections (USB Port 3/Port 4)
JUSBA1 USB2(3.0) Type A USB 3.0 header (Port 2)
JVRM1 VRM programming header (reserved for internal use only)
NVME10, NVME11 P1_NVMe1, P1_NVMe2; On-Board NVMe 1 and 2 for high speed PCI-E storage devices on CPU1
NVME12, NVME13 P2_NVMe1, P2_NVMe2; On-Board NVMe 1 and 2 for high speed PCI-E storage devices on CPU2
PSU1 Power Supply Unit 1
PSU2 Power Supply Unit 2
SATA 4,5 (Powered) SATA connectors with power-pins built-in with support of SuperDOM
SP1 Internal Speaker/Buzzer
S-SATA0-3 (SATA DOM) SATA 3.0 ports supported by Intel SCU