58
SuperServer E300-9A-4C/E300-9A-8C User's Manual
Enable/disable port
Use this feature to disable or enable the SATA port number. The options are
Enabled
and Disabled.
Hot Plug
Set this item to Enabled for hot plug support, allowing for a SATA disk drive to be replaced
without shutting down the system. The options are
Enabled
and Disabled.
Spin up
When the value of an edge detect or the value of an image binary (pixel) of a device is
from 0 to 1, select Enabled to allow the PCH to start a COMRESET initialization sequence
on this device. The options are Enabled and
Disabled
.
SATA1
SATA 1 Enable controller
This item enables or disables the onboard SATA controller supported by the Intel PCH chip.
The options are
Enabled
and Disabled.
SATA 1 LPM (Link Power Management)
When this item is set to Enabled, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link in a low power mode during extended periods
of I/O inactivity and will return the link to an active state when I/O activity resumes. The
options are Enabled and
Disabled
.
*If the feature above is set to Enabled, SATA 1 ALPM is available for configuration:
SATA 1 ALPM
Use this feature to enable or disable Aggressive Link Power Management. The options are
Enabled and
Disabled
.
SATA 1 SGPIO/LED
Use this feature to select SATA SGPIO or SATA LED. The options are SATA SGPIO and
SATA LED
.
I-SATA0 ~ I-SATA3, I-SATA (M.2)
This following information is displayed for each SATA drive entry:
•
Device Information
•
Device Size
