Supermicro SUPERSERVER 6028TP-HC0R-SIOM, User Manual

Page: 64 / 142

5-14
SUPERSERVER 6028TP-HTR/HC0R/HC1R-SIOM USER'S MANUAL
5-8 Connector Definitions
Main Power
Main power to the serverboard is supplied through the system backplane (BPN-
SAS3-217HQ), which receives power directly from the power supply. One hard drive
backplane in each node (BPN-ADP-3108L-H6IRP) plugs into system backplane and
the JF1 connector on the serverboard
Universal Serial Bus (USB)
Two USB 3.0 ports (USB 0/1) are
located on the rear I/O panel. See the
table on the right for pin definitions.
USB0/1
Pin
Definitions
Pin# Definition
1 +5V
2 D-
3 D+
4 Ground
5 RX-
6 RX+
7 Ground
8 TX-
9 TX+
IPMI LAN Port
An IPMI LAN port, located next to the VGA port on the rear I/O panel, provides
KVM support for an IPMI 2.0 interface. This LAN port is supported by the ASpeed
AST2400 Baseboard Management Controller (BMC) and accepts an RJ45 type
cable.
Note : Please refer to the LED Indicator Section for LAN LED information.
DOM Power Connector
A power connector for SATA DOM
(Disk On Module) devices is located
at JSD1. Connect an appropriate cable
here to provide power for your SATA
DOM devices.
DOM PWR
Pin Definitions
Pin# Definition
1 +5V
2 Ground
3 Ground