Supermicro SUPERSERVER 6028R-E1CR16T, User Manual

Page: 90 / 142

6-16
SUPERSERVER 6028TP-DNCR/DNCTR/DNCFR User's Manual
6-11 Drive Bay Installation/Removal
Accessing the Drive Bays
SAS/SATA/NVMe Drives: You do not need to access the inside of the chassis or
remove power to replace or swap drives. Proceed to the next step for instructions.
You must use standard 1" high, SAS/SATA/NVMe drives in the system.
Note: Refer to Supermicro's web site for setup guidelines: <http://www.supermicro.
com/support/manuals/>.
The chassis contains two individual serverboards in separate node
drawers (Figure 6-14). Each serverboard node controls a set of six hard drives.
Note that if a serverboard node drawer is pulled out of the chassis, the hard drives
associated with that node will power down as well.
Serverboard Drawer Locations in the Chassis
Serverboard A
Controls HDDs A
Serverboard B
Controls HDDs B
Figure 6-14. Hard Drives and the Corresponding Serverboards
1
A
1
B
SB: A
SB: B