Supermicro SUPERSERVER 6018TR-T, User Manual

Page: 27 / 144

Chapter 2: Server Installation
2-9
Figure 2-5. Accessing the Inside of the System
2-6 Checking the Serverboard Setup
After you install the SuperServer 6018TR-T/TF in the rack, you will need to open
the unit to make sure the serverboard is properly installed and all the connections
have been made.
Accessing the inside of the System
Before operating the server for the fi rst time, it is important to remove the protective
fi lm covering the top of the chassis, in order to allow for proper ventilation and
cooling.
Removing the Chassis Cover and Protective Film (Figure 2-5)
1. Disconnect the chassis from any power source and remove all four screws.
2. Gently push down on the chassis cover in the areas indicated in the
illustration.
3. Push the cover toward the rear of the chassis and lift the cover upwards and
off the chassis.
4. Peel off the protective fi lm covering the top cover and the top of the chassis
5. Check that all ventilation openings on the top cover and the top of the chassis
are clear and unobstructed.
1
3
1
2
1
2
1
3