Supermicro SuperServer 6014H-i, User Manual

Page: 55 / 126

Chapter 5: Advanced Serverboard Setup
5-21
VGA Enable/Disable
JPG1 enables or disables the VGA
Connector on the motherboard.
S e e t h e t a b l e o n t h e r i g h t f o r
jumper settings. The default set-
ting is enabled.
Jumper
Position
Pins 1-2
Pins 2-3
Definition
Enabled
Disabled
VGA
Enable/Disable
Jumper Settings
(JPG1)
3rd Power Supply Alarm
Enable/Disable
The system can notify you in the
event of a power supply failure.
This feature assumes that three
power supply units are installed in
the chassis with one acting as a
backup. If you only have one or
two power supply units installed,
you should disable this (the default
setting) with JP10 to prevent false
alarms. See the table on right for
pin definitions.
Jumper
Position
Open
Closed
Definition
Disabled
Enabled
Power Supply
Alarm Enable/Disable
Jumper Settings (JP10)
Watch Dog Enable/Disable
JWD enables the Watch Dog func-
tion. Watch Dog is a system moni-
tor that can reboot the system when
a software application is "hung up".
Pins 1-2 will cause WD to reset the
system if an application is hung up.
P i n s 2 - 3 w i l l g e n e r a t e a n o n -
maskable interrupt signal for the ap-
plication that is hung up. See the
table on the right for jumper settings.
Watch Dog can also be enabled via
BIOS.
Note: When enabled, the user needs
to write his own application software
in order to disable the WD Timer.
Jumper
Position
Pins 1-2
Pins 2-3
Open
Definition
WD to Reset
WD to NMI
Disabled
Watch Dog
Jumper Settings (JWD)