Supermicro SuperServer 6014H-i, User Manual

Page: 60 / 126

6-2
S
UPER
S
ERVER 6014H-i2/6014H-i/6014H-Xi Manual
Figure 6-1. Chassis: Front and Rear Views
System Reset
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected
to the JF1 connector on the serverboard to provide you with system status
indications. A ribbon cable has bundled these wires together to simplify the
connection. Connect the cable from JF1 on the serverboard to the appro-
priate header on the Control Panel PCB (printed circuit board). Make sure
the red wire plugs into pin 1 on both connectors. Pull all excess cabling out
of the airflow path.
The control panel LEDs inform you of system status. See "Chapter 3:
System Interface" for details on the LEDs and the control panel buttons.
Details on JF1 can be found in "Chapter 5: Advanced Serverboard Setup."
USB Ports System LEDs
Main Power
Slim CD-ROM Drive Slim Floppy Drive
IDE Drives
Mouse/Keyboard Ports
USB0/1 Ports GLAN (Ethernet) Ports VGA Port
COM1 Port PCI Expansion Slots
Power Supply
COM2 Port