Supermicro SUPERSERVER 2048U-RTR4, User Manual

Page: 122 / 152

7-32
SuperServer 2048U-RTR4 User’s Manual
sSATA Port 0~ Port 3
This item displays the information detected on the installed on the sSATA port.
specified by the user.
•
Model number of drive and capacity
•
Software Preserve Support
sSATA Port 0~ Port 3
Select Enabled to enable an sSATA port specified by the user. The options are
Disabled and Enabled.
sSATA Port 0 ~ Port 3 Hot Plug
Select Enabled to enable hot-plugging support for a port specified by the user,
which will allow the user to replace a sSATA disk drive installed on this port
without shutting down the system. The options are
Enabled and Disabled.
sSATA Port 0 ~ Port 3 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a
COMRESET initialization to the device. The options are Enabled and
Disabled
.
sSATA Port 0 ~ Port 3 sSATA Device Type
Use this item to specify if the sSATA port specified by the user should be
connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
*If the item above "Configure sSATA as" is set to IDE, the following items will
display:
sSATA Port 0~ Port 3
This item indicates that an sSATA port specified by the user is installed (present)
or not.
sSATA Port 0 ~ Port 3 sSATA Device Type (Available when a SATA port is
detected)
Use this item to specify if the sSATA port specified by the user should be
connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
*If the item above "Configure sSATA as" is set to RAID, the following items will
display: