68
Chapter 6: 200G Switch
6.3 Installation
Make sure the cover to the switch module has been installed before installation.
1.
Pull open the latch levers of the blade switch module.
2.
Slide the switch module into the bay until the module connectors seat in the enclosure.
3.
Push the latch levers closed.
The module will power on and a POST test will verify it is working properly.
Removing the Blade Switch
The switch module is hot-swappable. The blade enclosure and blades can continue to operate
when it is removed.
•
Pull open the latch levers and pull the module out of the enclosure.
