Supermicro SBI-6419P-T3N, User Manual

Page: 56 / 94

4-5
Chapter 4: Blade Module Features
CMOS Clear
JBT1 is used to clear CMOS and will also clear any passwords. This consists of two
contact pads located near the BIOS chip.
Clearing CMOS
1. First power down the blade and remove it from the enclosure.
2. Short the CMOS pads with a metal object such as a small screwdriver.
3. Replace the cover, install the blade back into the enclosure and power it on.
Jumper Settings
The following jumper settings can be used for the blade modules:
Table 4-4. Jumper Settings
Jumper
Default
Setting Notes
JWD1 Pins 1-2 Pins 1-2: Time to reset (Default); Pins 2-3: Timeout to NMI
JPME1/2 Pins 1-2
Pins 1-2: ME normal operation (Default); Pins 2-3: ME Recovery
Mode
JVRM1/2 Pins 1-2 Normal Operation (Default)