Supermicro SBI-6419P-T3N, User Manual

Page: 33 / 94

SBI-6419P-T3N SuperBlade Module User’s Manual
3-2
Removing a Blade Unit from the Enclosure
Although the blade system may continue to run, individual blades should always be
powered down before removing them from the enclosure.
Removing a Blade Unit from the Enclosure
1. Power down the blade unit (see "Powering Down a Blade Unit" above).
2. Squeeze the handle to depress the red section then pull out the blade unit from the
enclosure using the handle.
Note: Blade Modules can be Hot-Plugged from the enclosure.
Installing a Blade Unit into the Enclosure
Installing a Blade Unit into the Enclosure
1. Slowly push the blade unit into its bay with the handles fully pulled out (see
Figure 3-1 ).
2. When the blade stops, push the handle back into its locked position, making sure
the notches in the handle catches the lip of the enclosure (see Figure 3-3 ).
Note: Blade Modules can be Hot-Plugged into the enclosure.
Caution: Use extreme caution when inserting a blade module into the enclosure . If the
blade's power connector becomes damaged, it can damage pins on other blade bays that it
is inserted into.