Supermicro Intelligent Switch, User Manual

Page: 641 / 913

Release :
1.0
641 / 913
27.17 redist-config
This command configures the information to be applied to routes learnt from RTM and the no form of the
command deletes the information applied to routes learnt from RTM.
redist-config <Network> <Mask> [metric-value <metric (1 - 16777215)>]
[metrictype {asExttype1 | asExttype2}] [tag <tag-value>}
no redist-config <Network> <Mask>
Syntax Description
Network
- IP Address of the Destination route
Mask
- Mask of the Destination route
metric-value
- The Metric value applied to the route before it is advertised into the OSPF Domain
metric-type
- The Metric Type applied to the route before it is advertised into the OSPF Domain
tag
- The Tag Type describes whether Tags will be automatically generated or will be manually
configured
Mode
Router Configuration Mode
Defaults
metric-value - 10
metric-type - asExttype2
tag - manual
Example
smis(config-router)# redist-config 10.0.0.0 255.0.0.0 metricvalue
100 metric-type asExttype1 tag 10
tag <tag-value>: This is not used by OSPF protocol itself. It may be used to communicate information
between AS boundary routers. The precise nature of this information is outside the scope of OSPF. If
tags are manually configured, the futospfRRDRouteTag MIB has to be set with the Tag value needed.
Related Command
redistribute
– Configures the protocol from which the routes have to be redistributed into OSPF