A+ Server AS -1114S-WTRT User's Manual
24
3.3 Motherboard Components
Processor and Heatsink Installation
Follow the procedures in this section to install a processor (CPU) and heatsink to the
motherboard.
Notes:
•
Use ESD protection.
•
Power down the system as described in Section 3.1.
•
The motherboard should be installed into the chassis first and the processor should be
installed into the CPU socket before you install a CPU heatsink.
•
If you bought a CPU separately, make sure to use a certified multi-directional heatsink only.
•
When receiving a motherboard without a processor pre-installed, make sure that the plastic
CPU socket cap is in place and none of the socket pins are bent; otherwise, contact your
retailer immediately.
•
Refer to the Supermicro website for updates on CPU support. All graphics in this manual
are for illustration only. Your components may look different.
Installing the Processor and Heatsink
Begin by removing power from the system as descrbed in Section 3.1.
1. Use a Torx T20 driver to loosen the screws holding down force frame in the sequence of
3-2-1. The screws are numbered on the force frame next to each screw hole.
Screw #1
Screw #2
Screw #3
Force Frame
Figure 3-2. Removing the Processor Force Frame