- 8 -
RDO1BP B
INSTALLATION INSTRUCTIONS
1.
Mounting The Control Box
1.1
Establish a location at approximately chest height on the same wall face as that of the Door Mounting Bracket to
which Drive Unit will be secured. Make sure that the cable running from the Control Box is long enough to reach
up to the Drive Unit for the location that has been selected.
1.2
Use the Mounting Template provided on Page 16 to mark the location of the 3 Control Box mounting screws.
1.3
Drill a 6mm hole at each of the 3 marked locations to an approx depth of 75mm.
1.4
Insert a green wall plug (provided) into each of the 3 holes.
1.5
Insert a self tapping screw (provided) into each of the green plugs and leave the heads exposed from the wall
approx 6mm.
1.6
Locate the 3 recessed mounting slots on the center back of the Control Box base plate and “hook” the Control
Box onto the screws
Note: The mounting screws may need to be adjusted for depth if the Control Box will not
hook on to the screws or if the Control Box does hook on but is loose.
1.7
At this stage,
DO NOT
plug the Charger into a power socket.
2.
Fitting Of Drive Unit To The Door (Right Hand Installation Depicted)
2.1
Check that the door U-bolt is securely tightened on the opposite end of the door to which the Drive Unit will be
fitted (Fig.7)
2.2
Open the door fully and ensure that the bottom stoppers of the Garage Door are engaged with the stoppers on the
door guide tracks.
2.3
Place a suitable prop under the door as close to the edge (to which the drive unit is being fitted) as possible. The
prop should be adjusted so that it sits firmly under the door. (Fig.8)
2.4
Important Note: The door curtain can become damaged quite easily once the full weight of the door is
imparted on the prop. The prop must be strong enough to sustain the full weight of the door but at the
same time have enough padding that it will not damage the door curtain. The suitability of the prop should
be determined by a technically qualified person. No claims for door damaged will be recognized under the
terms of the AGDO’s warranty when using an unsuitable prop.
Fig 7 Fig 8