- 15 -
RDO1BP B
TROUBLE SHOOTING GUIDE
SYMPTOM
POSSIBLE CAUSES
REMEDY
Door will not operate
Mains power not turned on
Door is obstructed
Turn on mains power
Remove obstruction
Door is locked or motor
jammed
Mechanical door lock has been engaged
Unlock door
Inspect door and remove jam
Door will not reverse on
hitting an object
Safety Obstruction Force setting is too high
and may require adjustment.
Refer to Installation instructions,
- Items 8~10
Door moves
downwards and
reverses itself upwards
Safety Obstruction Force setting is too light
and may require adjustment.
Adverse weather conditions (wind or cold)
causing door to stiffen and become tight.
Possible obstruction under door
Refer to Installation Instructions –
Items 8 ~ 10
Door operates from
drive unit but not from
hand transmitter
Transmitter is damaged or broken
Transmitter Code has not been programmed
into the receiver
Control Box antenna wire not extended
Battery flat.
Try to operate the door with an
alternative transmitter
Refer to installation instruction
Item 5.
Locate and extend aerial wire
Replace battery(12V)
Door does not close
fully
Limit micro switch incorrectly adjusted
Re-adjust limit switch - Refer
Installation Instruction Item 3
Lights malfunction
globe blown
Replace with 24VDC/3W globe
Door Stops on Upward
cycle before reaching
the fully open position
Door may be obstructed.
Door springs may have lost tension
Safety
Obstruction
Force
may
need
adjustment
Disengage Opener and check
door for free movement
Call serviceman to affect repairs
Refer Section 8~10 of Installation
manual.
Auto close not working
P.E. Beam faulty or wiring broken
P.E. Beam obstructed
Auto close time not set
Repair P.E. or broken wire
Remove obstruction from the path
of beam.
Refer to installation inst. - Items
13 & 14.
TECHNICAL SPECIFICATIONS
CONFIGURATION:
Separate Control Box & Drive Unit
INPUT VOLTAGE:
230V or 115V 50~60 H (Selectable)
SECONDARY VOLTAGE:
24V AC 120 VA
CONTROLER VOLTAGE:
24V DC
OPENER LIFTING FORCE:
300N
OPENER OPENING/CLOSING LIMITS TRAVEL:
4.5 Turns of Door Drum Wheel
RECEIVER TYPE:
UHF 433.92 MHz Hopping Code
RECEIVER CODE STORAGE CAPACITY:
6 Transmitter Codes
TRANSMITTER FREQUENCY:
433 MHz
No. of CODE COMBINATIONS:
Over 4.2 Billion
TRANSMITTER BATTERY VOLTAGE:
12 Volt
MOTOR TYPE:
24 Volt DC Permanent Magnet
GLOBE:
15W 24 V DC Edison screw Type
SAFETY REVERSING SYSTEM:
Pot Adjustable Current Sensing
