Superiorfireplaces.US.com
126900-01_B
8
INSTALLATION
Continued
8. Thread gas control valve and burner inlet fitting into burner
manifold (see Figure 8). Use thread sealant on male threads of
burner inlet fitting. Secure with a wrench. Make sure control rod
is facing the front (see Figure 8).
9. To adjust regulator pressure, remove the brass hex plug from
regulator (see Figure 10).
10. Remove the plastic pressure button from the brass plug (see
Figure 10).
11. Reverse the plastic pressure button and replace it into the brass
plug (see Figure 10).
12. Replace brass plug into regulator.
13. Using two screws removed in step 2, page 7, replace valve cover.
14. Gently loosen and remove the pilot line connection from the pilot
bracket (see Figure 11).
15. Replace injector with propane/LP injector with red stripe.
16. Replace and tighten pilot line to bracket.
17. Using screws removed in step 2, page 7, reattach pilot bracket to
valve cover.
18. Continue with step 1 under
Hearth Pan Installation,
page 7.
Figure 9 - Burner Inlet Fittings with Injectors
NATURAL
GAS FITTING
PROPANE/LP GAS
FITTING
Injector for
Natural Gas
Injector for
Propane/LP
Gas
Figure 7 - Removing/Installing Cover, Control Knob, and Piezo
Ignitor
Piezo
Ignitor
Control Rod
Extension
Screw
Valve Cover
Control
Knob
Thermocouple
Ignitor
Pilot
Figure 8- Remove Burner Inlet Fitting
Burner Inlet Fitting
for Natural Gas
Control Rod
Control
Valve
Figure 10 - Adjusting Regulator Pressure for Conversion
Reversed Plastic
Pressure Button
for Propane/LP
Conversion
Plastic Pressure Button
Positioned for Natural
Gas
Regulator
Brass Plug
Figure 11 - Installing Propane/LP Pilot Orifice
Pilot Injector
Pilot Adjustment
Screw
Pilot
Bracket
