126817-01F
28
SuperiorFireplaces.us.com
OPERATION
Continued
FLAME HEIGHT
This function allows you to control height of fl ames
through 5 levels
(see
Figure 57
)
. Select manual
fl ame height function by pressing MODE button
until a fl ame is shown in lower left corner of display.
Use UP/DOWN arrow button to set desired fl ame
height
(see
Figure 56, Page 27
)
. A beep from
receiver confi rms the command.
ROOM THERMOSTAT
cordance to differences between set temperature
and room temperature. As room temperature gets
closer to set temperature the smart function will
modulate the fl ame lower. As room temperature
cools, it will modulate the fl ame higher.
To activate this function, press THERMOSTAT but-
ton until the word SMART appears to the right of
temperature bulb graphic on display. Use UP/DOWN
Figure 57 - Remote Control Display of Flame
Height Minimum and Maximum
ON
ON
MAX
MINIMUM
MAXIMUM
Figure 58 - Room Temperature Setting
ON
Room
Temperature
Set Temperature
The remote control can operate as a room thermo-
stat. The thermostat can be set to a desired tem-
perature to control the comfort level in the room.
To activate, press THERMOSTAT button on remote
control
(see
Figure 56, Page 27
)
. The word ON will
appear to the right of temperature bulb graphic on
display
(see
Figure 58
)
. Use UP/DOWN arrow button
to set desired room temperature. Control system
will cycle fi replace on or off to maintain selected
temperature.
SMART THERMOSTAT
The Smart Thermostat adjusts fl ame height in ac-
arrow button to set desired room temperature. The
control system will cycle the fi replace on or off to
maintain selected temperature.
CHILD SAFETY LOCK-OUT
This function lets you deactivate the remote control
buttons. It is active when the lock icon is lit on
SMART
MAX
Figure 59 - Smart Thermostat Setting
ON
Figure 60 - Child Safety Lock-Out
the display.
To activate, press MODE button and UP arrow but-
ton at the same time. To deactivate, press again.
REPLACING HAND-HELD REMOTE CONTROL
ONLY
If your remote ever needs to be replaced you will
not need to replace the receiver.
To program receiver with a new hand-held remote,
insert a small pin or paper clip into hole on receiver
face plate marked PRG. The receiver will beep 3
times to indicate it is ready to accept a new remote
transmitter. Press the ON/OFF button on your re-
mote and the receiver will beep 4 times to confi rm
it receives commands from the new remote.
ON REMOTE OFF
PRG
To
Program
Receiver
Figure 61 - Programing Remote Control to
Receiver
