Operation
900960-00C, 06/2019
Innovative Hearth Products
DRT3500-C Series Direct-Vent Gas Fireplaces
58
Installing the DRT3500-C 35 Series Oak Log Set
The logs have notches/tabs to assist proper positioning. Upper logs rest on lower logs via notches/tabs. Proper log placement is
critical to prevent sooting. Place the logs in the gaps between flame peaks, so they do not impinge the flames. Follow the log placement
instructions precisely.
NOTE: Do not cover the burner ports.
Table 30 - Oak Log Set
I.D. No.
Description
1
Rear Log
2
Bottom Left Log
3
Front Right Log
4
Twig Log
5
Bottom Right Log
1. If necessary, remove the glass door (
Pages 63-64
). Locate the placement tabs (
Figure 44
).
2. Bend up the log placement tabs (
Figure 44
).
3. Tear the glowing embers into dime size pieces. Place glowing embers as shown in
Figure 43
.
Figure 44 - Locate the log placement tabs/points
Figure 45 - Install Rear Log (1)
Catalog number for the
entire log set: See
Page 73
.
1
4
2
3
5
3
2
5
4
1
Do NOT place embers on or close to large
ports or the pilot area as seen here (circled).
NOTE: Enough glowing ember material is provided for several applications.
For best glowing effect, replace the ember material annually.
Figure 43 - Place glowing embers (rockwool)
Air Dam
Tabs for
Log #1
Tab & Dam
Log #2
Grate
Log #3
Grate
Log #5
4. Install rear log on two rear tabs (b & d) WW(
Figure 44 and 45
).
1
Front View
Bottom View
Pin for
twig #4
a
b
c
d
e
f
Fits over Tab “b”
(Figure 44)
Fits over Tab “d”
(Figure 44)
BEND UP TABS
Landing for
log #3
