If you have any questions during the setup process, please call a SuperCloset representative at 1.877.476.9787
1.
Make sure the cabinet is in its final location, as it will be more difficult to move
when fully assembled. We will not be plugging in any of the components just
yet. Let’s get everything in place first.
2.
Your cabinet comes with 5 Black Plastic Elbows (image a). You will have 3 2”
Elbows with Foam Tape affixed to one side, and two 1.5” Elbows with Foam
Tape.
3.
Locate your Power Strip (image c). Locate the two screws on the center rear
of
the cabinet. Your power strip has holes on it that fit on these screws for
mounting (image d).
4.
Locate and unpack the bubble wrapped T5 Light Strip located in your package.
The T5 comes equipped with magnetic backing and is mounted to the
underside ceiling of the cloning chamber (upper chamber) in this manner
(image e).
Once attached, run the T5 power cord through the nearest elbow o
f
the back of
the cabinet.
The exterior Elbows will allow you to run your cords out of your
cabinet with minimal light leaks and allow for fresh air flow into
your cabinet. The interior Elbow will facilitate airflow between
the Cloning Chamber and the Veggie/Flower Chamber.
a. Insert the foam side of the three 2” Elbows into large holes
located at the bottom corners and middle, in rear of the cabinet.
b. Insert the 1.5” Elbow with extension into the top hole in the rear
of the cabinet.
c. Insert the 1.5” Elbow into the top hole located in the interior of
the cabinet (image b).
We are now ready to set up the SuperCloset
Use masking tape and a marker to label the power cords of your
components at the plug to help identify your components later in
the assembly.
SUPER GROW TIP:
NOTE:
a
b
c
d
e
X3
