If you have any questions during the setup process, please call a SuperCloset representative at 1.877.476.9787
7.
Locate the Water Pump (image a). Attach the supplied 1/2” fitting to the
top of the Water Pump.
8.
Place the Water Pump in the SuperPonics® Reservoir near end with the
channel in the rim. Arrange the power cord of the Water Pump into the
channel located on the rim of the Reservoir (image b).
9.
Locate the Reservoir Lid and run the short end of the preassembled Ball
Valve and Drain Tube through the hole in the lid and connect it to the
tubing on the underside of the lid (image c).
10.
On the under side of the lid, locate the open end of the black tubing.
Attach the end of the tubing to the connector on the top of the Water
Pump. Return the lid to the Reservoir (image d).
11.
Now we can place our Net Cups into the openings of the top of the
reservoir. Once in place, arrange the top feed hoses to the center of the
net cups.
12.
Notice the length of tubing located on the top side of the reservoir lid
(image e) This is your Reservoir Drainage Tube. By opening the valve
(turning parallel to the tube) and turning the pump on, you can easily drain
your reservoir. See (image e) for open/closed positions.
13.
Place the SuperPonics system and Air Pump inside the cabinet with the
Drainage Tube towards the front.
14.
Now we can run our Air Pump and Water Pump power cords through the
lower opening in the back of the cabinet.
Read the instructions for the water pump, as they
contain valuable information on how to maintain this
component. THIS PUMP SHOULD NEVER RUN WHEN
NOT FULLY SUBMERGED IN WATER.
SuperPonic 8 System Assembly
NOTE:
Valve should always be in the CLOSED position,
unless you are draining your reservoir.
NOTE:
OPEN
CLOSED
a
b
c
d
e
