If you have any questions during the setup process, please call a SuperCloset representative at 1.877.476.9787
5.
Locate the power cord for the Carbon Filter and thread that cord
through the same opening as the power cord for the light.
6.
Locate the Internal Circulation Fan (image a). Note the “S” hook connected
to the base of the fan. This hook will fit into the notches located on the
backside of the inner door frame (image b). Mount the fan on one of the
lower notches. As your plants grow taller, move the fan to the upper
notches. Ideally the fan will blow air across the top of the plants. Thread the
power cord through the upper hole found on the lower interior of the cabinet
(same as the Light power cord).
7.
Locate the Thermometer/Hydrometer (image c). You will need to remove the
battery cover and remove the plastic safety blocker from the battery terminal.
8.
Use the included Velcro Strips to affix your Thermometer/Hydrometer to the
inside of your cabinet. The best placement for this is towards the top of the
cabinet, either on the side or back wall.
9.
Run the external probe to the outside of the cabinet, through one of the
openings in the bottom of the cabinet used for the power cords (image d).
Make sure the probe is not touching any surface on the out side of the
cabinet as this will give you false readings. This will read the outside (”out”)
temperature while the digital readout module will measure the inside
temperature and humidity.
Setting up the SuperCloset
a
b
c
d
