Superabrasive
User Manual Original Language
Lavina® 20G-X
4/2018
19
release water onto the floor surface. Starting the pump is possible only if the machine motor is on. When working dry,
check the floor surface periodically for dust accumulation. Check regularly to see if your vacuum works properly
STOPPING THE MACHINE
The stopping of the machine must be done gradually until the motor stops. Do not stop moving the machine before the
motor comes to rest, as the tools could damage the surface. To stop, push the Stop clutch rocker (2), then close (clockwise)
the service valve on the propane tank. ALWAYS allow the engine to run until it stops from lack of fuel.
• In case of emergency ONLY press the "stop" position on the Start/Stop Engine switch (1) and disconnect the fuel line from
the tank.
When finished with the machine, store the propane tank outside the building, in a
SECURE
place away from heat or direct
sunlight.
5. TOOLS AND ACCESSORIES
TOOL HOLDER KEY
The tool holder key (Fig. 5.1) is used for adjusting, mounting and dismounting of
the foam plates. Always use the key for mounting.
Item number is A03.00.00.00
FOAM PLATE
Diamond tools with Velcro are mounted on the foam plate
(Fig.5.2). The foam plate is mounted on the “QuickChange System” .
Item number is LV-9-FP-S
SECURITY PLATE FOR QUICKCHANGE PADS
Plate (Fig.5.3) used to ensure the “Quickchange” tools.
Item number is A38.00.01
Figure 5.1
Figure 5.2
Figure 5.3
