Super Superserver 5038ML-H24TRF, User Manual

Page: 68 / 108

6-6
S
UPER
S
ERVER 5038ML-H24TRF User's Manual
Figure 6-5. Installing/Removing 2.5" Hard Drives (Optional)
Note: Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the Supermicro
Web site at http://www.supermicro.com/products/nfo/storage.cfm
Installing/Removing SSDs from the Sled
1. Remove the sled from the chassis by following the procedure in the previous
section.
2. Place the sled on a fl at, non-conductive surface.
3. Insert two SSD drives with the printed circuit board side facing downward so
that the mounting holes in the drive align with those in the bottom of the sled.
4. Secure the drives to the sled with the screws included with the drive.
5. Place the other two SSD drives onto the optional bracket and secure with
screws as shown in step 1 in the fi gure below. The printed circuit board side
should face downward.
6. Secure the bracket with the SSD drives installed directly above the drives
already mounted in the sled with the screws provided as shown in step 2
below.
7. When fi nished installing or removing drives, push the node/sled back into the
bay it was removed from.
8. Use the node's power button to power it back on.
1
1
1
2