Operation
PT 30k to PT 33k
65
NOTE
Please note:
Only digits between 0 – 9 and letters between a – z and A – Z are permitted.
The password always has 8 characters. If the password you entered has less than
8 characters, the remaining characters are filled with "*".
Example:
Your password is "Solar". This password has 5 characters. The system automati-
cally appends three "*", so that the password becomes "Solar***".
3.
Open the menu "Settings – Network – Ethernet".
4.
Enter an IP address PC matching your PC. I.e. the first three number blocks
must be identical, the last number block different.
Example:
If your PC has the IP address 192.168.1.1, assign the IP address 192.168.1.2
to the Solar Inverter
5.
Call up additional settings with
.
6.
Enter the subnet mask
255.255.255.0
here.
7.
Enter the IP address of your PC in the gateway.
8.
Confirm with
.
After the connection is established, you can start the Sunways browser by ente-
ring the IP address of the solar inverter in the address line of your web browser.
PT 30k to PT 33k
Network settings on PC
To enable your PC to communicate with the Solar Inverter, you must assign net-
work settings. The procedure differs slightly depending on the operating sys-
tem. A configuration example under Windows
®
XP is shown below.
NOTE
IP addresses may not be assigned twice within the network!
1.
Select Start - Settings.
2.
Select Network Connections.
p
h
o
t
o
v
o
l
t
a
i
k
f
o
r
u
m
.
c
o
m
Summary of Contents for PT 30k
