2.4.2 Assembly of housing PP-100A
1.
Insert
(H)
Electrode through
(G)
PP Electrode Protective Housing
2.
Rinse
(H)
Electrode properly, so that it can be easily pass through
(I)
Rubber electrode
holder
,
leave about 5cm bellow.
3.
Install the prepared
(I)
Rubber electrode holder into
(G)
PP Electrode Protective Housing
and lock
(J)
PP pipe protective cover tightly.
4.
Insert
(H)
Electrode cable through
(D)
Lower cover of round junction box and
(C)
Cable
fixing point, and use
(D)
Lower cover of round junction box to lock
(G)
PP Electrode
Protective Housing tightly.
5.
Prepare 15cm cable in the PP pipe, and then lock
(C)
Cable fixing point MG16A tightly.
Leave
(H)
Sensing electrode cable for about 12-14cm, and split it carefully.
6.
Fix the terminal of electrode coaxial inner on terminal block 1 of round holder; Fix the
terminal of electrode coaxial shield on terminal block 3. (See the instruction of junction
box)
7.
Extend the cable to pass through
(E)
Cable fixing point on
(D)
Lower cover of round
junction box, and lock
(E)
Cable fixing point MG16A tightly, leaving 12-14cm in the box
for split.
8.
Extend the lead coaxial inner and electrode coaxial inner to connect them; extend the lead
coaxial shield to fix on the terminal block 3. Lock
(A)
Upper cover of round junction box
to finish the installation.
Mounting bracket:
A------ Upper cover of round joint box
B------ O-ring
C------ Cable fixing point MG16A
D------ Lower cover of round joint box
E------ Cable fixing point MG16A
F------ O-ring
G------ PP Electrode Protective Housing
H------ Electrode (Sensor
)
I------- Rubber electrode holder
J------- PP pipe protective cover
8