FORM NO. 660769 REV. C
PAGE 27
2-K
Installing the Cylinders
Steps:
1. Orient cylinders with
Rod End
and
Spacers
pointing forward.
2. Apply grease to pins.
3. Mount cylinder end to
Cylinder Mount Tube
with pin, washers and cotter pins.
4. Mount
Rod End
to
Lower Arm
, with pin, washers and cotter pins.
5. Repeat for opposite side of
SwiftShield™
.
5. Make sure jam nut is tight against cylinder rod flange.
6. After both cylinders are installed you may connect hydraulic lines to the Power Pack.
Cotter Pin
4 Places
Pin .75” X 4.5”
2 Places
Washer .75” 4
Places
Cylinder
Mount Tube
Lower Arm
Rod End Spacers
4 ea 1” spacers
1 ea .5” spacer
1 ea .25” spacer
2.
3.
* Hydraulic hoses not shown.
Summary of Contents for SWIFTSHIELD A Series
Page 5: ...FORM NO 660769 REV C PAGE 5 SwiftShield Overview Continued Lines shown disconnected...
Page 8: ...FORM NO 660769 REV C PAGE 8 1 B Remove The contents of the Power Pack box Pump RC Unit Battery...
Page 12: ...FORM NO 660769 REV C PAGE 12 1 F Drill Manifold Mounting Holes Location Of Mounting Holes...
Page 13: ...FORM NO 660769 REV C PAGE 13 1 G Mounting the Pump Note Mount pump using the holes on the left...
