6
• Questions? Call or Text +1-801-658-0015
Orion
™
150
s
Users Guide
• Remove the stylus hull (E) by pulling it away
from the stylus shaft (A). See Figure 6.1.
• Loosen the collet cap (C) by twisting it counter-
clockwise.
• The welder accommodates 0.5mm and 1.0mm
electrodes. The electrode stylus will be shipped
with the 1.0mm electrode collet (B) installed.
• Insert a 1.0mm electrode (D) into the collet.
Helpful Tip: There is a goove on the side of
the stylus hull (E) that helps measure the
electrode length. Place the end of the stylus
hull (E) against the collet cap, then make sure
the electrode extends to the groove as indi-
cated. See Figure 6.2.
• There should be between 0.6 - 0.7 inch (1.5 –
2cm) of the electrode (D) protruding from the
stylus shaft (A). This will allow the electrode
enough room to stick out from the stylus once
the stylus hull (E) is placed back on the stylus.
• Lock the electrode (D) into place by hand tight-
ening the collet cap (C) in a clockwise direction.
• Replace the stylus hull (E) by pushing it in until
you feel it snap back into place. The electrode
(D) should stick out between 1/8 – 1/4 inch
(3.175 – 6.35mm after the stylus hull is snapped
back into place). See Figure 6.3.
Adjusting The Microscope Focus
• Twist the knob on the microscope forward and
backward to lower and raise the head. This
will allow you to focus the microscope on the
welding stylus. See Figure 6.4.
•
Place your finger under the welding electrode
to help judge the correct focus location. Focus
the microscope until the texture on the skin of
your finger is clearly visible.
Figure 6.4. Turn
this knob to adjust
microscope focus.
You’ll find one knob
on each side of the
microscope arm.
Figure 6.1. To install the electrode, first remove the stylus
shaft (A) from the stylus hull (E) by pulling them apart.
Figure 6.2. Use the guide engraved on the side of the
stylus hull (E) for proper electrode (D) positioning.
Figure 6.3. The electrode should protrude past the
stylus hull (E) 1/8 to 1/4 inch (3.175 to 6.35mm).
Summary of Contents for Orion 150s Series
