Questions? Call or Text +1-801-658-0015 •
25
The Micro Welder Experts
•
If you notice that your weld head is frequently misfiring, check your tip shape first, but then you
should try adjusting this value down. Try to only adjust by 100-200µs at a time, because this
delay can make a big difference.
• If you notice your electrode is sticking to the surface frequently, or that you are getting too
much contamination on your tip, try increasing this value. Adjust by 100-200µs at a time,
because this delay can make a big difference.
•
Tip Descend Delay (ms):
This parameter is primarily useful for a manual (non-CNC) weld
head. Adjust this value to give sufficient time for the nose cone to descend before the elec
-
trode begins descending to make a weld.
•
Tip Retract Distance (mm):
This parameter controls how far the tip will be off the surface
after a weld occurs. Lower values can be used for smoother surfaces. Higher values can be
used for rough surfaces or if weld spots are close together.
•
Agitation Options:
Adjust the agitation frequency, duty cycle, and weld percentage.
•
Gas Options:
View gas pressure gauge and adjust gas flow timing. Tapping on the gas gauge will cause
a purge of the gas line. When accessing this Mini-Screen from the Weld Head screen, an option labeled
Continuous Gas Flow is available. Enable this setting if a separate shielding gas system is set up, as this
setting will cause the welder to not regulate the gas, allowing faster welding rates. For more information
about Gas Options, see page 34.
•
Dynamic Energy Adjustment Mode:
This Mini-Screen is only available in Arc mode. Enable or Disable
the mode and adjust the desired percentage. When this mode is active, operators may press the foot
pedal to momentarily change the weld energy by the set percentage. You can choose to increase or
decrease the weld energy by up to 50% while the foot pedal is pressed. This can be useful for making
Figure 25.1. You are able to
customize the information displayed
in the Mini-Screen Area. Touch the
drop down arrow to view a list of
available options.
