Questions? Call or Text +1-801-658-0015 •
5
The Micro Welder Experts
MOUNTING OPTIONS
Mounting Option 1 - Clamp to Table
This option is best for tables with accessible edges and
for mounting without drilling holes in the table.
Note: If your table is thicker than 3-1/2” (9cm), follow
the instructions for mounting options 2 or 3 on the next
page.
Hardware required from Box 2:
(1) Angled Bracket C
(1) Sunstone Microscope Arm Assembly A
(1) Clamp Mechanism D
(5) Flat Head Hex Screws G
• Lay the arm assembly down on the tabletop.
• As shown in Figure 5.1, attach the angled
bracket (C) to the bottom of the arm using three
(3) of the included flat head hex screws (G)
using a 4mm (5/16”) Allen wrench (L).
• Attach the clamp mechanism (D) to the angled
bracket using two (2) of the included flat head
hex screws. See Figure 5.2. For thicker tables,
attach the clamp mechanism D to the two lower
holes in the angled bracket C.
• Adjust the knob on the clamp mechanism (C)
until the gap is sufficient for the thickness of
your tabletop.
• Lock the arm into place by turning the knob
on the clamp mechanism until the clamp is
pressing firmly against the bottom of the table.
• Lift the arm assembly up and slide the arm onto
the table as shown in Figure 5.3.
• A plastic cable guide cover (E) can be clipped
on over the angled bracket if desired. See
Figure 5.4
Figure 5.1. Attach angled
bracket C to A
Figure 5.2. Attach clamp
mechanism D to angled
bracket C.
Figure 5.3. Attach clamp
mechanism D to angled
bracket C.
Figure 5.4. Cover the clamp
mechanism D with the plastic
cable guide cover E.
