21
High
Low
③
②
①
[Fig. 4-22]
[Fig. 4-24]
[Fig. 4-23]
[Fig. 4-25]
1) Lubrication to Bed
Loosen the oil tank entrance screw
①
and supply oil until the oil gauge
②
reaches the “HIGH” mark
③
. When oil
supply is completed, tightly fasten the screw
①
. Upon initial installation, run the machine for 30 minutes and
supply oil until the “HIGH” mark.
2) Lubrication to Face Plate
isassemble the faceplate by loosening two faceplate screws and supply oil to the indicated part as shown in the
figure. After lubrication, reassemble the faceplate.
3) Lubrication to Hook
Open the slide plate
③
and supply oil to the indicated part as shown in the figure.
4) Oil Window Check
Turn on the power after lubrication on each sliding part and check the oil flow at the oil window
⑤
on the front
part of the arm by rotating the sewing machine at low speed for five minutes. Operate the machine at the rate of
2,000spm during four or five days after starting to use it, then machine performance will continue to be in best
shape.
4.6) Supplying oil
•
Operate the machine only after supplying oil when the machine is used for the first time or has been
left unused for a long time.
•
Only use genuine lubricant of this company. (Lubricant is in the accessory box.)
Caution
•
Plug in only after oil supply is finished. If the operator mistakenly steps on the pedal with the plug in,
the machine will start automatically and can cause severe injuries.
•
When handling lubricants, wear protective glasses or gloves to prevent lubricants from contacting
with your eyes or skin. Wash your hands in running water with soap when they are smeared with
lubricant. If lubricant is in the eye, instantly wash it with running water and see a doctor.
•
Never drink lubricants since they can cause vomiting or diarrhoea. Go to see a doctor, if you
mistakenly drink lubricant.
•
Keep lubricant away from the reach of children and the youth.
Caution
④
⑤
Summary of Contents for KM-1170BLX
Page 2: ......
Page 14: ...14 Fig 4 5 Thread trimming ...
