42
2 Millennium Issue 7
Fig. 64
Axle
Fig. 63
Rear wheel camber
The camber block accommodates
0° and 3° camber.
Wheel camber is preset at the
factory at 3°.
The camber block (1) is adjusted by
removing bolt (2) with a 5mm Allen
key and 13mm A/F spanner.
Slide out the camber block (1), turn
upside down, slide back and
replace bolt (2). Tighten to 7-12Nm.
torque. The setting is now 0
o
.
To identify, the 3
o
setting has the
notch on the upper inner side
(Fig. 64A).
To identify, the 0
o
setting has the
notch on the lower inner side
(Fig. 64B).
When the QR axle bracket is in the
downwards position the notch
should be pointing outside of frame
(Fig. 64C), but notch in lower
outside for 3
o
and upper outside for
0
o
camber setting (Fig. 64D).
NOTE
Both axles must be set in an
identical manner. Drawings refer to
right side of chair.
1
2
A
B
C
D
Summary of Contents for QUICKIE 2 Millenium
Page 1: ...Owner s Manual EN G LISH 2 Millennium...
Page 2: ...63 2 Millennium Issue 7...
Page 61: ...57 2 Millennium Issue 7...
Page 62: ...58 2 Millennium Issue 7...
