20
Adjusting In and Out Limits of the Awning
•
The motor on your awning is mounted on the right, as you face the house, complete Steps 2 thru 6.
•
Press the Neutral/Stop button on the remote.
•
From a stepladder locate the two 4mm limit Allen screws on the motor. These screws will be colored.
One will be red, and one will be white. These are the limit screws for the IN and OPEN positions for
the motor on the awning.
Limit settings
•
To adjust the inward setting of motor, locate the Allen screw that is red and turn it counter clockwise
or towards the plus (+) sign to close the awning tighter. You must run the awning motor by using the
remote control while adjusting the limit. Fig 6
•
To adjust the outward setting of the motor, locate the Allen screw that is white and turn it clockwise
or towards the plus (+) sign to increase the projection of the awning. Be sure not to “LOCK” the arms
or allow the fabric to sag when making this adjustment. The arms should stop just before the lock
position. The fabric will also be at it tightest point.
NOTE:
The fabric should be rolling over the top of the roll tube (figure
4
), not underneath (figure
5
).
If the fabric is rolling from the bottom of the roll tube, continue unrolling the fabric until it rolls over the
top of the roll tube. Then roll up the fabric until both lateral arms
‘lock’ and the fabric become tight.
Figure 4
Figure 5
Figure 6
Summary of Contents for Retractable Awning
Page 33: ...Page Page 40 38 ...
