18
Very important technical parameters and MV Station related parameters are
contained in the nameplate.
Protect the nameplate at all times!
4.3
Checking for Transport Damages
The MV Station has been strictly inspected and tested before delivery. Despite robust
packaging, the container or inside devices may be damaged during transport. Therefore,
once receiving the MV Station, perform a detailed inspection
If any damage is found, contact the shipping company or Sungrow immediately.
•
Check the scope of delivery described in
for completeness.
•
Check that the MV Station and internal devices match the models included in the original
order.
•
Check thoroughly the MV Station and internal devices for any possible damages caused
during transport.
Install and commission the MV Station only when it is technically faultless! Make
sure before installing the MV Station that
•
MV Station is intact without any damage;
•
all devices inside the MV Station are intact without any damages.
4.4
Storage of the MV Station
If it is not to be installed immediately after delivery, store the MV Station appropriately:
•
Store the MV Station indoors, for example large warehouse or workshop to prevent
possible condensation or damp.If the MV Station has to be stored outdoors, elevate the
MV Station base according to the field geological and ambient conditions. And when the
ambient temperature is too low, heat the MV Station internal devices.
•
Temperature: -40°C~+70°C; Relative humidity: 0 ~95%, non-condensation
Store the MV Station in a dry, clean and solid ground with sufficient load capacity. The
ground should be flat without water, bumps or plantings.
•
Lock the MV Station internal devices and the MV Station during storage.
•
Take proper protection method to prevent the water and dust penetrating inside the MV
Station internal. At least protect the MV Station air inlets and outlets.
•
Regularly check the MV Station and internal devices, at least once every half a month.
System Manual
