Controller Dimensions
Depth 45mm (1.77in) width 180mm (7 in) length 104mm (4.1 in)
Distance between holes for mounting 164mm (6.5 in)
Net weight is approximately 350g
Installation
Mounting - The charge controller is designed to be mounted flush with the wall.
Flush mounting requires a rectangular cutout in the mounting surface with sufficient space (2-3
inches) behind to accommodate the controller and wiring.
The charge controller may also be mounted to the wall without making a cutout. The controller
will be raised from the wall; this is the quickest and easiest mounting procedure.
CONNECTION DIAGRAM
Connection Procedures (please refer to the connection diagram above)
1. Once the controller has been properly mounted select either Lead – Acid or Gel – Cell
Battery modes, (refer to label below).
2. Connect the solar panel positive side to the charge controller “ARRAY” positive (+) with a
suitable wire. Be careful not to short circuit the solar array.
3. Connect the solar panel negative side to the charge controller “ARRAY” negative (-) with a
suitable wire.
4. Connect the battery positive side to the charge controller “BATTERY” positive (+) with a
suitable wire.
5. Connect the battery negative side to the charge controller “BATTERY” negative (-) with a
suitable wire.
