http://www.sunflower-solar.com/
Version 11.04
Subjec
t to c
hang
e 2011 SUNF
LOWER SOLAR
10
5.2 Assemble the water cylinder (water tank)
Please check the water cylinder and make sure there is nothing inside of it. If there is, please try to take
it out. Put the assembled frames on level ground, or install them in their final place of operation, e.g. on
the ground or on a roof
(If on roof, aerial work, please pay attention to safety)
.
Remove the nuts from
the screws at the end of water tank.
Then two workers hold onto the two ends of the tank, and put the tank onto the gantry carefully.
Please try to let the screws go through the long notch on the gantry. You may need to gently turn the
cylinder to achieve it.
Then screw the nuts back onto the screws of the tank so that the tank can be fixed on the frame.
Note:
"Do not tighten the bolts completely. Just make them snug. You may need to turn the tank so that
the heat pipe tubes line up with the bottom tube holders. Once the tubes are installed, then tighten the
bolts completely so the tank is firmly connected to the stand."
