Sunex DROPS D4.1, Operating Manual And Assembly

Page: 21 / 24

-21-
Start-up protocol of the heat pump DROPS D 4.1
Copy for the Manufacturer of a device
1
.............................................. ......................................................
........................................
Stamp/signature of dealer Stamp/signature of installing company Signature of investor
1
In the event of malfunction of the heat pump “ The start-up protocol ” is attached to the complaint notification, to be sent
to the manufacturer. The Protocol is the basis for defining the correctness of the selection and installation method of
the device.
Device serial no
Name and address of the Investor
Name and surname of
the actuating person
Place of installation
(e.g. cellar)
Air ducts
Diameter: Material:
Heating pipeline
Diameter: Material:
Heating diagram corresponding
with the operating instructions
HUW tank capacity
Feed temp. - heat pump*
Return temp. - heat pump*
Diagram no: Other:
Condensate drainage
method
Electrical connection
Name and surname of
the person performing
Overcurrent Protection
Residual-current
device
Cross-section of
the power cord
Heater Yes No Circulation pump Yes No
Notes
Start-up date
* Note the temperature of the storage container down during the measurement. The temperature of the storage
container during the measurement should not be lower than 30º
C .