10
Fixture A: Fixture for edge module Fixture B: Fixture for intermediate modules
For the 30 frame, the recommended value of X is 29mm For the 30 frame, the recommended value of Y is 20mm
For the
35
frame, the recommended value of X is 34mm For the
35
frame, the recommended value of Y is 25mm
For the
40
frame, the recommended value of X is 39mm For the
40
frame, the recommended value of Y is 30mm
Figure 4 Assembly fixture installation method
6.3.3.4
When clamping the fixture to the frame of the module, use spring washers, flat washers and bolts to fix
the module on the mounting frame. Note that both ends should be clamped in a symmetrical position in the
center. M8 bolts and matching The screw is fixed, and the torque of the screw i
s from 18N·m.
6.3.3.5
If there is large snowfall or snow pressure in the module installation area and large wind pressure, it is
recommended that the customer adopt a 5400Pa reinforced installation solution to clamp the fixed module (as
shown in Table 2 recommendations) to increase the front of the module Resistant to static snow pressure and
dynamic wind pressure on the back, improving the system's pressure resistance.
Table 2 The clamping range of the fixture
Note
:
A: Length of this type of module.
B: Width of this type of module.
C: The distance of clamp center1 from the short edge of this type of
module.
D: The distance of clamp center 2 from the short edge of this type of
module.
E: Clamped width of the module frame by the clamp of this type of
module.
F: Clamped length of the module frame by the clamp
of this type of module.
G:The distance of clamp center3 from the long edge of this type of
module.
* Note:
Sunerg limited warranty will be void in cases where improper clamps or installation methods deviating from this manual are
used. When using clamps to fasten the modules, pay attention to the following requirements:
