21 |
3 Assembly
3.1 Assembling the umbrella
Take umbrella main body out carefully from carton, and place flat on the clean
ground, find the crank handle
7
from the accessory bag, put it into the hole
5
and turn anticlockwise direction to move the sliding tube
2
down through the
support tube
4
, till the block point on the sliding tube hits the slider
3
.
Take out umbrella standing tube, and insert it into the triangular part,
with the protrusion part on the standing tube facing the recess, screw
holes matching to each other. And fix with bolts by Allen key, both of
which you will find in accessory bag.
3.2 Set up umbrella in base
CAUTION:
Be sure to use our matching umbrella base intended for this free arm umbrella, other bases may not
fit with our umbrella, and could cause safety problem. Make sure base is properly assembled, filled with water
and sands, secure and horizontal before putting umbrella in. Two persons are required to set up the umbrella in
the base.
Erect the ready assembled umbrella with one person
holding the umbrella top part, and another person hold-
ing the standing tube, place the umbrella slowly into the
base, till the standing tube hits the bottom of standing
tube seat
L
, and blockade ring
9
fits in the fixation
ring
M
, placed at top inside the tube seat
L
, and mean-
time, the fixation ring
M
fit by teeth in the tube seat.
After the umbrella standing tube has been into the base.
Tighten the union nut
K
clockwise direction to fix um-
brella securely into the base.
